Common problems in the production of corn processing equipment

发布时间：2024-12-02 点击次数：

In the production of corn processing equipment, we often encounter a variety of problems, affecting the normal production of 

equipment, and due to prolonged use or improper operation of the problem, so that the equipment in the use of some problems,

 affecting the normal production, the quality of processed products also have an impact. Next, I analysed the common problems 

in the production of corn processing equipment for your reference.

1, spiral agitator fault. Stirrer shaft does not turn, the reason is to feed too much, drive belt slipping, etc.; grain outlet does not 

discharge grain, because there is a motor steering is not right, the outlet is blocked, stirrer blade cracking, etc..

2, because the wind is not good, the bag can be sucked on. Common causes are air leakage at the articulation, impeller wear, etc.

 If the impeller is worn out, you can add a rubber plate on the outer edge.

3, motor fault. Corn processing equipment has more than 10 motors of varying sizes, thus, the motor problem can not be ignored,

 the temperature is too high is one of the main reasons for motor damage. Causes of high temperature are bearing oil shortage, 

bearing into the dirt, bearing damage or motor overload and so on.

4, before use must first understand the various parameters of corn processing equipment and performance. The use of personnel

 in the use of corn processing machinery before the various parameters and performance have a detailed understanding, in order 

to good to operate the use of machinery. In the process of use if there is a problem that can not be solved, no matter how big or

 small, can not be forced to use and maintenance, must be timely with the after-sales contact.

5, consider the corn processing equipment  protective measures, in strict accordance with the code of maintenance of corn 

processing equipment for routine maintenance. If you find corn processing equipment in the operation of some small problems, 

must stop for inspection and maintenance, forced use can only avoid unnecessary economic maintenance costs.