Troubleshooting methods for different fault phenomena

发布时间：2024-05-13 点击次数：

Failure phenomenon (a): peeling not clean

　　This problem is a corn grits processing machinery often encountered problems, and the impact is relatively bad, peeling is not clean to affect the late milling, so as to affect the quality of the finished product, and salvage is more difficult, it is a very headache for customers, machinery once such a problem, will lead to stop working for troubleshooting and maintenance, if your corn grits processing machinery such problems can be contrasted to solve the problem, but Problems are often complex changes, so you can compare, but to treat individual problems individually, if the following solution can not solve your actual problem, please contact the manufacturer!

　　Failure causes: 1, feeding too much crop; 2, drum speed is not enough; 3, the crop is too wet.

　　Remedy: 1, reduce the appropriate amount of feeding; 2, adjust the belt tension, adjust the drum speed; 3, crop drying before peeling.

　　Failure phenomenon (2): corn grits processing machinery motor load fever

　　Failure causes: 1, feeding too much crop; 2, belt too tight; 3, insufficient voltage; 4, motor failure.

　　Elimination methods: 1, reduce the amount of feeding; 2, appropriate loosening of the belt; 3, a full-time electrician to check the exclusion; 4, repair or change the motor.

　　Failure phenomenon (c) slag outlet blockage

　　Failure causes: 1, insufficient speed; 2, crop moisture; 3, feeding too much.

　　Remedy: 1, adjust the rotational speed; 2, the crop should be dried before threshing; 3, feed the right amount, uniform.

　　For the corn grits processing machinery running problems, we need to find the source of the failure and to solve it, so that we can effectively troubleshoot and extend the use of equipment cycle.