Stable production with all components in balance
发布时间：2024-01-15 点击次数：
After the purchase of corn flour complete sets of equipment or or after the replacement of some important parts have a period of break-in period, so that the components are in a balanced production state, you can guarantee the stability of production. But in the corn meal sets of equipment in the break-in period, there are some faults occur, let's learn about it!
1, corn meal sets of equipment leakage phenomenon occurs due to the loosening of the machine parts, vibration and machine heat, the sealing surface of the machine as well as pipe joints, etc., there will be a leakage phenomenon; part of the casting, machining and other defects, it is difficult to find in the assembly debugging, but due to the vibration of the operating process, impact effect, this defect is exposed, manifested as oil leakage. Therefore, the break-in period is prone to leakage.
2, poor lubrication due to the newly assembled parts of the fit gap is small, and due to assembly and other reasons, it is difficult to ensure the uniformity of the fit gap, the lubricant is not easy to form a uniform oil film on the friction surface to prevent wear. This reduces the lubrication efficiency, resulting in early abnormal wear of the parts. Serious cases will cause the friction surface of the precision fit scratching or occlusion phenomenon, resulting in failure.
3, wear fast due to cornmeal equipment parts processing, assembly and adjustment and other factors, the friction surface is rough, with a small surface contact area, the surface of the pressure situation is not uniform. Corn meal sets of equipment in the operation process, the parts of the surface of the concave and convex part of the friction embedded in each other, grinding down the metal debris, but also as an abrasive, continue to participate in the friction, more accelerated parts with the wear of the surface. Therefore, the break-in period is easy to cause wear and tear of parts, wear and tear fast. At this time, if the overload operation, it may lead to damage to the parts, resulting in early failure.
4, loosening occurs in the new processing and assembly of parts, there are geometric shapes and with the size of the deviation, in the early stages of use, due to shock, vibration and other alternating loads, corn flour sets of equipment, as well as heat, deformation and other factors, coupled with wear and tear is too fast and other reasons, it is easy to make the original fastening of parts and components to produce loosening.