Repeated cleaning of de-powdering sites to ensure effective use

发布时间：2023-08-23 点击次数：

Powder buildup in the corn milling equipment should be handled with the suction chamber regulator valve, suction tube and auxiliary air holes. When there is powder buildup in the variable section suction tube, the end or ends of the supply holes should be opened and reformed with high velocity air. After repair, the supply orifice should be adjusted to its original open condition. Powder buildup in the cyclone suction tube is low. If there is powder buildup, air can be replenished at the ends of the straw. At present, most of the powder removers use the equal cross-section suction method, which is easy to accumulate powder. In order to ensure the processing quality of corn, it is often necessary to repeatedly clean the de-powdering place, supplemented by air supply treatment.    

　　After the corn milling machine equipment is used up, the personnel must carefully clean the grinder, mainly cone sieve and flat sieve. If the cleaning is not clean, it will cause clogging and affect work efficiency. WARNING: Do not touch the corn milling machine equipment being produced directly with your hands to avoid accidents or abrasions. It can be removed in time, remove the grinding head and clean it again to ensure the effect of future use.

　　In addition, the corn milling machine equipment should develop good maintenance habits, regularly overhaul all kinds of electrical parts and solve problems in time. In addition, in order to make the operation faster, check the short circuit protection device. The focus is to strengthen the comprehensive management of equipment operation and strict accountability. Regular inspection and observation and monitoring of each shift of maintenance personnel can effectively reduce failures and improve work efficiency