Adjustment of corn milling equipment round sieve and wind screen

发布时间：2023-07-26 点击次数：

We all know that corn through the processing of corn milling equipment in order to achieve the desired flour, in fact, the main can assist the corn flour to meet the factory standards, mainly sifter, and corn milling equipment round sieve and wind mesh adjustment methods are as follows;.

　　Corn milling equipment round sieve adjustment

　　Corn milling equipment round sieve adopts a skeletonless structure, flour machinery and equipment round sieve consists of sieve drum, sieve mesh, sieve core, two brushes, two beaters, four fins cards, shafts, bearings, front and rear rood cover and other components.

The sieve mesh is tensioned and locked when in use. Brush and screen mesh clearance 0-2 mm is appropriate. The gap between the brushes and the screen is 0-2mm. The distance between the beating plate and the screen is 7-15mm.

　　Attention: the coaxiality of the rotating parts and the sieve core and shell, the reliability of the bolt, and the bevel angle of the beating plate, so as to avoid too much material in the sieve memory, which will affect the rotation and the sieve clean rate.

　　Corn milling equipment wind screen adjustment

　　Corn milling equipment wind screen debugging, according to the grain needs, adjusting the adjustment of flour machinery and equipment dampers, to achieve the first grinding of corn, this time the skin into a bin, the coarse core into a bin, the second continue to grind the large bran, the basic clean bran.

At this time, the basic clean grinding of bran into a warehouse, rough core into a warehouse, corn milling equipment grinding two times, the flow do not put too much to ensure that the bran is basically clean. The third time first shut off the small flow, tighten the grinding roller, and start grinding the rough core. The fourth time is still grinding the core slag, until the slag contains not much powder.

　　The fifth time at the same time open the bran, heart slag warehouse eyes, mill flow open, grinding rollers loose, mixed flow once can be.