Corn flour milling machinery for sifted flour is not fine solution

发布时间：2023-07-14 点击次数：

Corn flour milling machinery sieving not fine reasons may be:    

　　(1) the sieve mesh of the sieve mesh is blocked (to increase the anti-clogging device)

　　(2) The sieve frame pressure mesh strip is not front extension

　　(3) Vibrating screen surface feeding uneven (to increase the material diverter)

　　(4) put into the vibrating screen material moisture is too large (viscosity, appropriate after drying into the vibrating screen)

　　(5) The material layer on the screen surface of the vibrating screen is too thick (increase the material diverter, control the amount of feeding).

　　Corn flour milling machinery to solve this problem:

　　(1) often to reduce the load of light vibrating screen and clean up the vibrating screen mesh

　　(2) change the inclination angle of the screen box, mediate the feeding amount of vibrating screen, tighten the screen, close the drive belt

　　(3) Vibrating screen frame nailed to the pressure bar forward 2 centimeters, the screen mesh hanging nailed to the outstretched pressure bar, to prevent material mixing