Need to check the vertical position of the bias block

发布时间：2023-07-07 点击次数：

Corn processing machinery manufacturers in the high square flat sieve in the process of operation need to operate very little, the operation of the equipment accessories - flat sieve itself is mainly start and stop; in the face of the maintenance of the flat sieve, testing and adjustment work is an important part of the grinding production process.             

　　High square flat sieve is huge, heavy equipment, with a fault start is likely to cause a larger accident, once the equipment is running, troubleshooting is also more difficult, so before starting in the miscellaneous grain milling equipment manufacturers need to carefully check the sieve body hanging device, barn door, transmission mechanism, import and export pipe connection cloth cylinder and other parts, ready to start the equipment. The flat sieve must be started at a complete standstill.

　　Corn processing machinery manufacturer should pay attention to the movement state of the sieve body during the operation, and observe whether the amplitude of the four corners and the top and bottom of the sieve body is consistent. If it is found that the amplitude of the four corners is not equal, it should check whether the bin is blocked and whether the hanging device is normal; if the amplitude of the upper and lower amplitude is not equal, after excluding the influence factors such as blockage in the bin, the vertical position of the bias block needs to be checked during the equipment maintenance.

　　When the whole corn processing machinery to stop, need to stop the flat sieve first. After the flat sieve stops running, the other flour mill accessories equipment that is broken material.