Reduce wear and tear on parts due to irregular operation

发布时间：2023-05-22 点击次数：

In the operation of the corn milling equipment, will lead to many parts due to friction and other reasons by different degrees of wear and tear, thus reducing the service life of the components, so the need for staff to do a good job of maintenance work, in order to effectively extend so that the corn milling equipment cycle, to ensure production.      

　　For corn milling equipment these easy to wear parts, we should pay attention to the use of a maintenance, take regular lubrication, overhaul, another to operate correctly to reduce the wear and tear of parts due to non-standard operation aggravated, such as the discovery of wearing parts can not be used to replace in a timely manner, to avoid triggering other parts damage and equipment failure.

　　In the use of corn milling equipment in the process to regularly check whether the fixed nut of the movable tooth plate is loose and all the fastening parts should not be loose. In particular, you should check the screws inside the fixed tooth plate. Before starting the machine to the flour machine inject appropriate lubricating oil, for continuous work should be appropriate to increase the number of refueling. After 300 hours of actual work, the spindle bearing cavity must be maintained and cleaned and replaced with new lubricant. In the replacement of the flour machine wearing parts, should be familiar with the corn milling equipment repairman operation, if there is a large damage contact the manufacturer for maintenance.