The use of corn flour machine should pay attention to

发布时间：2022-06-01 点击次数：

1. The uniformity of grinding particles. When the particle sizes of the material particles entering the same grinding system are very different, some smaller particles will not be subjected to grinding, so the output will be affected. If it is to be avoided, this difference should be minimized to ensure uniformity.

2. The capacity of grinding materials. After the corn is ground one by one, the endosperm is gradually scraped off. With the push back of the number of rind grinding, the bulk weight of the material is reduced, and the unit flow rate of the corn deep processing equipment is also reduced. It can be seen that it is very important to learn to control the amount of raw materials added.

3. The height of the grinding teeth. During the grinding process, with the gradual wear of the grinding teeth, it is not easy for the grinding teeth to grasp the material, and the sliding on the surface of the grinding roller increases, the material in the gap between the two grinding teeth decreases, and the output will gradually decrease. At this time, pay attention to timely replacement or adjustment.

4. Adjust the crushing degree of the material. When operating the equipment, the length of the grinding area increases with the reduction of the rolling distance. At this time, the number of teeth acting on the material by the fast roller increases, and the degree of pulverization increases.