• Contacts:Milo Wang
  • Tel:+86 400 6662589
  • E-mail:1714716253@qq.com
  • Fax:+86 530 3368803
News

Correct use of corn grits machine

发布时间:2022-05-23 点击次数:

1. Before the operation, the working parts such as the machine head, the movement and the lead screw should be removed, and the rice scale and oil stains on the movement and the lead screw should be carefully cleaned, and then dried and reassembled after cleaning.

2. When using the corn grits making machine, start the machine for 1 minute to 2 minutes, then slowly add the raw material into the feeding port, and when about a handful of raw materials can fill the ring groove of the screw shaft head, stop feeding and carry out friction preheating . When the temperature of the standby head rises, the pressure in the machine cavity increases, and the nozzle starts to eject, then feed the material. Since the machine cavity has not reached the normal temperature and pressure at this time, the feeding amount should be gradually increased slowly.

3. The feeding should be continuous and uniform, and the material should be dry, otherwise the spiral groove will be easily blocked.

4. When it is found that the spiral groove is blocked, do not stop the machine immediately, it should run for a while after stopping the feeding, and then stop the machine when there is a burning smell. In this way, the nozzle and the screw sleeve can be prevented from being seized. In case the nozzle and screw bushing are bitten and cannot be removed, do not knock them hard, but remove them from the body and burn them in a fire for a while to remove them.

5. When the nozzle holes of the corn grits making machine cannot spray the formed product at the initial stage of operation, it is often caused by the high temperature of the nozzle. The reason is that the raw material is too dry, or there are foreign objects in the spiral groove, or the feeding is interrupted. Find the cause and troubleshoot. After the operation is finished and the feeding is stopped, let the machine idle for 1 minute, and then stop the machine after draining the material in the machine. Then remove the nozzle and screw sleeve while it is still hot, punch out the screw shaft, remove the residue in the machine, and clear the nozzle hole for reuse.


Versatile corn peeling machine|Beans dry way peeling machine|Corn peeling & grit milling plant|Flour milling machine|Flour milling plant|Cleaning machine|Flat milling machine|SiteMap