Precautions for the use of pulverizers

发布时间：2022-05-18 点击次数：

1. During the use of the pulverizer, there should be fixed personnel to take care of it, and the operator must have a certain technical level. Before installation, the operator must have the necessary technical training to make them understand the principle and performance of the mill and be familiar with the operating procedures.

2.The feeding must be carried out according to the specified standards, otherwise the particle size will be uneven, coarse and fine, which will affect the grinding effect.

3.It is necessary to grasp the adjustment of the air volume, and adjust it appropriately according to the fineness and output requirements; whether the air volume is too large or the air volume is too small, it will have a bad influence on the effect of the Raymond mill after the mill.

4. Secondly, after the mill has been used for a period of time, it should be overhauled, and at the same time, the wearing parts such as the grinding roller, grinding ring, blade, etc. should be repaired and replaced. The connecting bolts and nuts of the grinding roller device should be carefully checked before and after use to see if there is any looseness Phenomenon, whether the lubricating grease is added enough.

5. Master the correct shutdown method. Before shutdown, stop feeding in advance. After a while, wait until there is no remaining material in the mill bin before powering off. After stopping the grinding work, stop the fan motor. , to blow off any remaining powder.