Grinding and Refining Machine Instructions

发布时间：2022-05-11 点击次数：

Grinding and pulping machine: It is composed of feeding hopper, grinding disc, regulator and other parts. After the material enters the machine body through the feeding hopper, it forms fine powder (slurry) under the strong grinding action of the two grinding plates and is discharged through the discharge port.

Before feeding the grinding mill, adjust the adjusting handwheel until you hear a slight friction sound of grinding discs, then slowly open the material stop switch, and fine-tune the handwheel until the processed powder (slurry) is fine and suitable. Tighten the locknut. When refining, soak the raw materials for several hours before processing. When refining, add an appropriate amount of water. Too little will affect the refining effect, resulting in no flow of slurry and increase the power load. Too much water will affect the quality of the refining.

The operator should stand on the side of the feeding port, his hands should not go deep into the feeding port, and the machine cover should not be opened during operation.

When the feeding port is blocked, it is forbidden to forcibly feed it by hand, hardwood sticks, chin sticks, etc. Stop the machine and cut off the power supply when removing the blockage.

After the material is discharged from the discharge port, it will be transported by air for 1 to 2 minutes, and the plug plate should be closed to prevent debris from entering. After the machine stops running, open the cover and remove the remaining material in the machine to prevent the remaining material from being damp, mildewed, and affecting the quality of the next processing material.