Two discharging methods for flour processing equipment

发布时间：2021-03-22 点击次数：

The processing technology of flour processing equipment is more complicated, because the flour processing equipment is a flour processing production line composed of many supporting equipment, so it contains more accessories and more process steps. Among them, the discharging method includes self-flow discharging. There are two ways of suction and grinding chamber. Each discharge method has its own method and advantage. Let's understand these two discharge methods of flour processing equipment:

1. Grinding chamber suction is to set up a vertical pneumatic conveying suction pipe between the two units of the compound mill to directly lift the crushed material from the discharge hopper. The pot-shaped catcher occupies a smaller height than the induced catcher, but the pressure loss of pneumatic conveying is large, and the reliability is not as good as the induced catcher. Due to the limited space in the grinding chamber under the grinding roller, once the pneumatic conveying material drops, the grinding chamber will be blocked within a few seconds, so it is better to use a grinding chamber suction machine with a grinding chamber anti-blocking alarm device.

2. Gravity discharge means that the crushed materials fall into the discharge hopper at the bottom of the flour mill, and are discharged out of the machine by gravity flow or enter the corresponding conveying system. When this discharge method is used, a floor space is required under the flour processing equipment for installation The driving motor of the conveying device and the flour machine.