Operation and maintenance of corn blasting machine

发布时间：2020-11-22 点击次数：

1. Before driving, check the import and export of the equipment, the condition of the screen surface and the material accumulation in the machine, and check whether the striking mechanism is flexible.

2. After the corn blower is started, confirm that the striking mechanism is operating normally and start feeding to normal working flow. Randomly check the difference in the surface conditions of the incoming and outgoing materials, the condition of the broken wheat and the foot. If there is any abnormality, it should be adjusted in time.

Check the working current of the motor frequently during the working process. If the current is too large, the material inside the machine may be blocked or the working flow may be too large.

3. Before stopping, cut off the feed in this process, stop after the corn harvesting equipment is emptied, and finally close the wind net.

4.The key maintenance objects of the corn smashing equipment are the striking mechanism and the working screen surface. Once damage is found, it should be replaced in time. When replacing the slab, pay attention to the dynamic and static balance of the entire rotating system. Generally, it is not allowed to replace a single piece, and pay attention to the slab The relationship between angle and installation position.

When installing the screen surface, check the roundness of the screen surface to prevent uneven working gap.

The sieve surface should be cleaned frequently to make the sieve holes unobstructed to facilitate removal of impurities.